Activating Test Mode - ABB Relion 650 Series Commissioning Manual

Section 4
Testing IED operation
4.2
30
In LHMI the sensitive directional earth fault protection SDEPSDE parameter group
4 is active indicated by the * next to #4 and the test of the SDEPSDE must be
performed according to the instructions given for the setting OpMode and setting
value 3I03U0cosfi.
Set and configure the function(s) before the testing can start. Most functions are
highly flexible in that it permits a choice of functional and tripping modes. The
various modes are checked at the factory as part of the design verification. In
certain cases only modes with a high probability of coming into operation need to
be checked when commissioned to verify the configuration and settings.
Requirements for testing the function.
• Calculated settings
• Valid configuration diagram for the IED
• Valid terminal diagram for the IED
• Technical manual
• Three-phase test equipment
Content of the technical manual.
• Application and functionality summaries
• Function blocks
• Logic diagrams
• Input and output signals
• A list of setting parameters
• Technical data for the function
The test equipment should be able to provide a three-phase supply of currents (and
for some START functions also voltage). The magnitude and angle of currents
(and voltages) should be possible to vary. Check that the IED is prepared for test
before starting the test session. Consider the logic diagram of the function when
performing the test.
The response from a test can be viewed in different ways.
• Binary output signals
• Service values in LHMI (logical signal or phasors)
• A PC with PCM600 (configuration software) in debug mode

Activating test mode

The IED shall be put into test mode before testing. Test mode blocks all functions
in the IED and the individual functions to be tested can be unblocked to prevent
unwanted operation caused by other functions. In this way, it is possible to test
1MRK 511 209-UEN -
REC650
Commissioning Manual