GRE PSR-255 Owner's Manual page 14

Notes:
h To reverse the search direction at any time, hold down \/
or /\ for about 1 second.
h To search the band upward or downward in small incre-
ments (in steps or 5 of 12.5 kHz, depending on the band),
repeatedly press and release \/ or /\.
The scanner stops when it finds an active frequency.
3. To store the displayed frequency in the channel currently
flashing on the display, press E. The scanner stores the
frequency, then the next available channel flashes and
continue the search.
Notes: After you store a frequency into the last available chan-
nel, – –CH appears instead of a channel number. If you try to
store a channel while – –CH appears, Ch FULL appears
briefly. In order to store more frequencies, you must clear
some channels. See "Clearing a Channel".
Direct Search
You can search up or down from the currently displayed fre-
quency and store the frequency into the monitor memory.
1. Press MANUAL or PGM, then use the number keys and
DLY/. to enter the frequency where you want to start the
search.
Note: To start from a frequency already stored in one of
your scanner's channels, press MANUAL or PGM, enter
the desired channel number, then press MANUAL or PGM
again.
2. Hold down /\ or \/ for about 1 second to search up or
down from the selected frequency.
When the scanner finds an active frequency, it stops
searching.
3. To store the frequency in the monitor memory, simply press
MON. MON appears on the display.
4. To continue the search, hold down /\ or \/ for about 1
second.
14