Connecting The Antenna; Using The Belt Clip; Connecting An Earphone/Headphones - GRE PSR-255 Owner's Manual

CONNECTING THE ANTENNA

Follow these steps to attach the supplied flexible antenna to
your scanner.
1 Align the slots around the scanner's connector with the
tabs on the ANT jack.
2. Press the antenna down over the jack and turn the
antenna's base clockwise until it locks into place.
Connecting an Optional Antenna
The ANT jack on the top of the scanner makes it easy to use
the scanner with a variety of antennas. Instead of the sup-
plied antenna, you can attach a different one, such as an
external mobile antenna or outdoor base station antenna.
Follow the installation instructions supplied with the antenna,
route the antenna cable to the scanner, then connect it to the
ANT jack.
Warning: Use extreme caution when installing or removing
an outdoor base station antenna. If the antenna starts to fall,
let it go! It could contact overhead power lines, if the an-
tenna touches a power line, contact with the antenna, mast,
cable or guy wires can cause electrocution and death! Call
the power company to remove the antenna. Do not attempt
to do so yourself.

USING THE BELT CLIP

You can use the belt clip for hands-free carrying when you
are on the go. Simply slide the belt clip over your belt or
waistband.
CONNECTING AN EARPHONE/
HEADPHONES
For private listening, you can plug an earphone or mono
headphones with a 3.5 mm plug into the PHONE jack on top
of your scanner. This disconnects the internal speaker.
Caution: To protect your hearing, follow these guidelines
when you use an earphone or headphones:
7