Preparing The Condensed Water Container For The Softsteam Program - Miele TXR 860 WP Operating Instructions Manual

Condensed water container
Preparing the condensed
water container for the
SoftSteam program
During the SoftSteam program, the
condensed water collected in the
condensed water container is sprayed
into the drum via a spray jet. The
condensed water container must
therefore be filled with water to at least
the –min– marker. Otherwise, this
could cause a fault.
The –min– marker is at the front left-
hand side of the container.
Make use of the condensed water
which collects during the drying
process.
Filling the empty condensed water
container
 You can fill the condensed water
container with commercially available
condensed water (ironing water).
You should only use tap water in
exceptional circumstances. If tap water
is used frequently, however, the spray
jet (in the door opening) can become
calcified.
46
1 spout, 2 rubber seal
 Pour the water in through the rings of
the spout 1.
The spray jet in the door opening can
suffer a blockage.
It should only be filled with clean
water. The water must not contain
any fragrance, detergent, or other
substances.
Check the rubber seal from time to
time
If tap water is used frequently, white
limescale deposits can build up on the
rubber seal 2.
 Use a damp cloth to carefully remove
any limescale deposits from the
rubber seal 2.