Preparing The Condensed Water Container For Steam Smoothing - Miele TKG 440 WP Operating Instructions Manual

Cleaning and care
Preparing the condensed
water container for Steam
smoothing

Condensed water which has
collected in the condensed water
container is directed into the drum in
the Steam smoothing programme.
The condensed water container
must therefore be filled with water up
to at least the –min– marker.
The –min– marker is at the front left-
hand side of the container.
 Make use of the condensed water
which collects during the drying
process.
If the condensed water container is
empty
 You can fill the condensed water
container with commercially available
condensed water (ironing water).
You should only use tap water in
exceptional circumstances. If tap water
is used frequently, the Steam
smoothing spray jet (in the door
opening) can become calcified.
40
1 spout, 2 rubber seal
 Pour the water in through the rings of
the spout 1.

Only use clean water. The water
must not contain any fragrance,
detergent or other substances.
Check the rubber seal from time to
time.
If tap water is used frequently, white
limescale deposits can build up on the
rubber seal 2.
 Use a damp cloth to carefully remove
any limescale deposits from the
rubber seal 2.
 After cleaning the rubber seal, push
the condensed water container fully
into the dryer.