Table of Contents
Advertisement
Condensed water container
Preparing the condensed wa-
ter container for the Steam
Care program
During the Steam Care program, the
condensed water collected in the con-
densed water container is sprayed into
the drum via a spray jet. The con-
densed water container must therefore
be filled with water to at least the
–min– marker. Otherwise, this could
cause a fault.
The –min– marker is at the front left-
hand side of the container.
Make use of the condensed water
which collects during the drying
process.
Filling the empty condensed water
container
You can fill the condensed water con-
tainer with commercially available
condensed water (ironing water).
You should only use tap water in excep-
tional circumstances. If tap water is
used frequently, however, the spray jet
(in the door opening) can become calci-
fied.
46
1 spout, 2 rubber seal
Pour the water in through the rings of
the spout 1.
The spray jet in the door opening can
suffer a blockage.
It should only be filled with clean wa-
ter. The water must not contain any
fragrance, detergent, or other sub-
stances.
Checking the rubber seal from time
to time
If tap water is used frequently, white
limescale deposits can build up on the
rubber seal 2.
Use a damp cloth to carefully remove
any limescale deposits from the rub-
ber seal 2.
Advertisement
Table of Contents
