Setting Serial Data For Expansion - Advantech FPM-7211W Series User Manual

C.1

Setting Serial Data for Expansion

The several kinds of timings below are already programmed in this module.
The input synchronous signals are automatically recognized.
Resolution
IBM, 720 * 400
VESA 640 * 480
VESA 640 * 480
VESA 640 * 480
VESA 800 * 600
VESA 800 * 600
VESA 800 * 600
VESA 800 * 600
VESA 1024*768
VESA 1024*768
VESA 1024*768
VESA 1152*864
VESA 1280*720
VESA 1280*800
VESA 1280*1024
VESA 1280*1024
VESA 1366 * 768
VESA 1440 * 900
VESA 1680 * 1050
VESA 1920 * 1080
Note! Even if the preset timing is entered, a little adjustment of the functions
such as Horizontal period, CLK-delay and display position, are required.
The adjusted values are memorized in every preset number.
Note! This module recognizes the synchronous signals with near preset timing
of the frequency of the HS and Vsync, even in the case that the signals
other than the preset timing that were entered.
Note! Because adjustments may not fit, such as differing magnifying ratios or,
in the case that you use it except for the display timing that was preset.
Recommend best resolution as 1920*1080.
FPM-7211W Series User Manual
HSYNC /KHz (+/-) VSYNC /Hz (+/-)
31.469 70.087
31.469 59.940
37.861 72.809
37.500 75.000
35.156 56.250
37.879 60.317
48.077 72.188
46.875 75.000
48.363 60.004
56.476 70.069
60.023 75.029
67.500 75.000
45.000 60.000
49.702 59.810
63.981 60.020
79.976 75.025
47.712 59.790
55.935 59.887
65.290 59.954
67.500 60.000
32
PIXEL RATE /MHz
28.322
25.175
31.500
31.500
36.000
40.000
50.000
49.500
65.000
75.000
78.750
108.000
74.250
83.500
108.000
135.000
85.500
106.500
146.250
148.500