Table of Contents
Advertisement
_________________________________________________________________________________________
Manage
Open Browser: Opens the web browser interface for the selected AR.
Upgrade Firmware: Starts the Firmware Upgrade dialogue. Firmware
Upgrade requirements: Valid firmware
Set
IP Address: Changes the IP address of the selected AR.
Factory Defaults: Return the selected AR to a Factory Default state. This action must be
performed within the first 2 minutes after powering up the unit.
Local Address: Select the IP address to Discover on. This may be necessary for computers with
multiple network connections.
Exit
Exits the DMU program.
Help
Online Help: Opens a web browser to online help resources.
About: Displays DMU version information.
2. Setting the IP Address
ARs are configured with a DHCP assigned factory default IP address.
To set the AR's IP address using one of the following methods, the computer and AR must be on the same local
network.
DMU: Follow the steps in the preceding subsection to set the IP address using the
Device Management Utility (DMU).
CLI: These are the basic commands to set the network parameters. After setting these parameters, the AR
will need to be rebooted for the settings to take effect. Any command that requires rebooting of the AR
will provide a prompt to do so. All commands may be entered as required before rebooting. Manually specifying
the IP address via CLI automatically sets the address as static.
© 2019 AMETEK Electronic Systems Protection | Technical Support: 800-645-9721 | surgex.com
SA-82-AR
file. Administrative login
credentials.
"Upgrade Enable" must be set to yes, set via web page or CLI.
User Manual
5
Advertisement
Table of Contents
