Table of Contents
Advertisement
_________________________________________________________________________________________________________________________
5. AutoPing Commands
Command
get autoping
set autoping < 1 | 2 > address < dotted decimal >
set autoping < 1 | 2 > frequency < 1-999 >
set autoping < 1 | 2 > failcount < 1-999 >
set autoping mode < single | and | or >
set autoping action < none | on-latch | on-follow | off-latch |
off-follow | cycle | cycle-once >
set autoping cycle <0-999>
set autoping restart <1-999>
6. User Commands
Command
set password < user | admin > < old > < new > < repeat >
set user account <yes | no>
set login required <yes | no>
© AMETEK Electronic Systems Protection, Inc. | Technical Support: 800-645-9721 | surgex.com
SA-82-AR
Description
Returns all AutoPing settings currently in use. Example:
AutoPing 2
IP Address:
10.1.2.36
0.0.0.0
Frequency:
60
10
Fail Count:
3
3
Status:
OK
OK
Trigger Count: 0
0
--------------------------------------
Mode:
Single Action:
On-Latch
Sets the IP address to be pinged for AutoPing 1 or 2.
Sets the frequency (how often the ping is sent) for
AutoPing 1 or 2 in seconds.
Sets the number of consecutive failures the AutoPings must detect
before the AutoPing considers the pinged device to be failed.
Sets single AutoPing (AutoPing 1) or two AutoPing relationship
AND or OR.
Sets the action to be performed when the AutoPing is triggered.
Sets the maximum number of power cycles when the AutoPing
triggers. 0 = Unlimited
Sets the delay in seconds to restart AutoPing tests after Action.
Description
Sets the password of the User or Administrator.
Sets whether or not a user account is used.
Sets whether or not a login is required for user level operation. A login
is always required for admin functions.
User Manual
Admin
Fact Def
Yes
AutoPing 1
Yes
0.0.0.0
Yes
10
Yes
3
Yes
AND
Yes
None
Yes
1
Yes
0
Admin
Fact Def
Yes
user | admin
Yes
No
Yes
Yes
17
Advertisement
Table of Contents
