Table of Contents
Advertisement
SA-82-AR
User Manual
_________________________________________________________________________________________
II. Installation
1. Ethernet Connection
The RJ45 connector for 10/100 Ethernet is situated on the rear panel beside
the input power plug. The default IP Address is DHCP assigned. The fallback IP
address is 192.168.1.254.
2. AC Power Connections
Connect the device to be powered On and Off to the output duplex receptacle.
Ensure that the total combined load of all controlled devices does not exceed 8
Amps.
Connect one end of the supplied power cord to the connector labeled "AC Input",
and the other end to a properly grounded AC outlet.
3. LED Indicators
The green Self-Test LED indicates that the internal surge protection circuitry is
fully functional. The red Outlet On LED indicates that power is being supplied to
the two receptacles.
The red System On LED indicates that the Axess system is On. This indicator will turn off if the AC voltage rises above
145V, and AC power will be removed from the output receptacles in order to protect connected equipment. When
the AC voltage returns to below 135V, power will automatically be restored to the output receptacles and the System
On LED will turn on.
© 2019 AMETEK Electronic Systems Protection | Technical Support: 800-645-9721 | surgex.com
3
Advertisement
Table of Contents
