Calibration data updating
Open the control software MCTRL-mars, then Click "Settings"→Click "Module Flash" going
to the interface as shown below:
Choose "Auto Upload Module"
Flash Check :Checking if the module flash is working
View Calibration coefficients in receiving card: View the calibration coefficients in the
receiving card which the new module is in.
Check coefficients in modules : View and update calibration data from module flash.
Save Calibration coefficients in receiving card: Send the calibration coefficients in the
receiving card which the new module is in.
Save to HW: Save the calibration coefficients in the receiving card which the new module
is in.
106