Checking For Blockages; Maintenance - Shark NV105 Owner's Manual

Checking for Blockages

Blockages may cause your vacuum
to overheat and shut down. If
this occurs, clear the blockages,
then follow the instructions for
Resetting the Motor Thermostat
on page 11.
IMPORTANT: Never insert sharp
objects into any opening to clear
an obstruction. Damages caused
while clearing or attempting to
clear blockages are not covered
under your product's limited
warranty.
Unplug the vacuum
before checking for
blockages.
Reassemble all parts
securely before
operating vacuum.
Fig. 22
1
DUST CUP AIR DUCT:
3
Stand vacuum upright.
Remove Dust Cup Assembly and
empty Dust Cup if necessary.
Check Air Duct behind Dust Cup
for clogs; clear before replacing
1 Dust Cup Assembly. (Fig. 21)
2 HOSE INTAKE OPENING:
Hold the top of the hose access
door and pull firmly to remove.
Slide the knob to the center and
pull out the hose. (Fig. 22)
Remove any obstructions and
2
push the hose back in.
Slide the knob to the left and
snap the hose access door shut.
10 TOLL FREE: 1-800-798-7398
Fig. 21
Fig. 23
3
HOSE:
Disconnect the Stretch Hose by
gently pressing the tabs together
and pulling away from the hose
connector.
Remove hose from both the unit
and handle ends. (Fig. 23)
Inspect the length of the hose
and remove any obstuctions.

Maintenance

Get even more cleaning from your Shark
Navigator
Resetting the Motor Thermostat
Your Shark ® Navigator ™ is
equipped with a protective Motor
Thermostat. If the motor should
Bookmark the page and check back often
overheat, the thermostat shuts off
to take advantage of the latest products,
the power.
ADDITIONAL ACCESSORIES (AVAILABLE FOR PURCHASE):
MULTI-TOOL
Convenient crevice tool and dusting brush in one.
PET/UPHOLSTERY TOOL
Removes hair from upholstery and stairs.
CREVICE TOOL
Reach deep into narrow spaces and clean between cushions,
under radiators and baseboards and in hard to reach crevices and
TO RESET THE MOTOR
corners.
THERMOSTAT:
NOTE: Some accessories may be included with your
Press the Power Button ( )to turn
purchase.
the unit "Off".
Unplug the vacuum.
Check for clogged hose or filter;
To order Additional Parts &
unclog hose and replace filter.
Accessories go to
Refer to Checking for Blockages
www.sharkclean.com.
on page 10.
Wait 45 minutes for vacuum to cool;
then plug in the vacuum.
Press the Power Switch ( ) to start
the vacuum.
NOTE: If vacuum still does not start,
contact Customer Service at:
1-800-798-7398.
by checking out our cleaning
™
accessories assortment at
www.sharkclean.com.
promotions and prices!
PART PART NO.
Stretch Hose
Multi-Tool
Foam & Felt Filter
Extension Wand
24" Crevice Tool
11" Crevice Tool
Pet/Upholstery Tool
www.sharkclean.com
English
®
126FFJ
127FFJ
XFL100
1116-FC
122FFJ
129FFJ
128FFJ
11