Service Information; Maintenance; Switchgear Extension & Retrofit; Spare Part Orders - Siemens 8BT2 Installation And Operating Instructions Manual

7.2.

Service information

7.2.1.

Maintenance

7.2.2. Switchgear extension or Retrofit
7.2.3.

Spare part orders

7.2.4. Replacement of panels and components
Replacement of
switchpanels
Replacement of
components
7.2.5.

Disposal

881-4027.9 * INSTALLATION AND OPERATING INSTRUCTIONS 8BT2 * Revision 04
• No original Siemens spare parts are used.
• Assemblers who carry out the replacement have not been trained and certified for this work
by Siemens.
• The parts are mounted or adjusted incorrectly.
• Adjustments are not made according to the stipulations of Siemens.
The vacuum circuit breaker is maintenance-free within the range of the permissible operating
cycles. Under normal environmental and operating conditions, the switchgear has maintenance
intervals of 5 years.
The switchgear can be extended on both sides without having to modify existing panels.
Please contact SIEMENS with the following data:
• Detailed description of your modification
• Serial number (please see fig3, page13, pos.nr.3)
• Panel number
• If possible, photos with explanations
Contact:
E-mail: aftersaleskartal.tr@siemens.com
Tel: +90 216 459 3434
Required information when ordering spare parts for single parts and devices:
• Type and serial number of switchgear as per rating plates
• Precise designation of the device or component, if applicable on the basis of the information
and illustrations in the associated instructions, a drawing, sketch or circuit diagram
Panels can be replaced after undoing the panel connecting bolts.
If you are planning to replace a panel, please contact your regional SIEMENS representative,
as the replacement must only be done by experts with special tools.
The individual components such as measuring instruments, current transformers, etc can be
replaced. Please contact your regional SIEMENS representative for replacing components.
8BT2 switchgear is an environmentally compatible product.
All metal plates are powder-coated with resistant epoxy resin material.
The switchgear materials should be recycled if possible. The switchgear can be disposed of in
an environmentally compatible manner in compliance with existing legislation.
The components of the switchgear can be recycled as mixed scrap; however, dismantling as far
as possible into sorted scrap with a residual mixed scrap portion is the more environmentally
compatible way.
Electronic scrap has to be disposed of in accordance with the existing regulations.
The switchgear consists of the following materials:
• Sheet steel, powder-coated
• Copper
• Aluminum
• Cast resin
91