Advertisement
Remote Start Valet Mode
Enter / Exit Valet mode for systems using an Flashlogic FLRS kit.
1.
Cycle ignition ON five times [5x OFF/ON] rapidly. (complete this step
within 7 seconds)
2.
Wait, LED 1 (on the FLRS kit) will turn solid RED for 2 seconds.
3.
Turn ignition to OFF position.
4.
Valet Mode Programming Procedure completed.
NOTE: In Valet Mode, the Remote starter is not functional. On units with Keyless
Entry, Lock and Unlock will remain functional. To exit valet mode: repeat steps 1 to 4.
Remote Control Programming
1.
Cycle the vehicle ignition ON.
2.
Press and release the Valet button 3x.
2.
Press 1 button of each transmitter you wish to program, the LED's will
flash to confirm each transmitter.
3.
Turn the vehicle ignition OFF.
NOTE: This system has 1 button programming which programs all channels of the
system.
NOTE: The system will hold up to 4 transmitters in memory, programming a 5th
transmitter will erase the oldest transmitter in memory.
4
2018 Voxx Electronics Corporation. All rights reserved.
Advertisement
