Programming Bank 3 (Remote Start) - Prestige APSRS1Z Installation Manual

PROGRAMMING BANK 3 (REMOTE START ):
You can enter Bank 3 from Bank 2 by turning the ignition key off then on after you have
made the changes you wanted in Bank 2, (Pk. Lts flash twice). You can also go right
to Bank 3 by:
1. Turn the ignition key to the on position.
2. Press and release the valet/programming switch 3 times (Lights flash once).
3. Turn the ignition key off then on (lights long flash).
4. Turn the ignition key off then on (lights 2 long flashes).
5. Press the pushbutton switch once to advance to feature 1, twice to advance to feature
2, etc,,,then use the transmitter button to select the feature setting.
Example to set engine input check to DBI Tach:
1. Turn the ignition key to the on position.
2. Press and release the valet/programming switch 3 times (lights flash).
3. Turn the ignition key off then on. (lights long flash)
4. Turn the ignition key off then on. (lights two long flash)
5. Press the pushbutton switch five times to advance to features 5, Input Check, then
use the transmitter button to select three chirps, "DBI Tach"
6. To exit the programming mode, turn the ignition key off. The program mode is
automatically exited when there is no activity on the pushbutton switch or the
transmitter lock button.
TACH RATE PROGRAMMING:
1. Turn the ignition key to the On position.
2. Press and release the valet/program push button switch 3 times.
3. Immediately turn the ignition key Off.
4. Press and hold the valet/program push button switch, then start the vehicle using
the key.
5. When the unit senses the tach signal, the parking lights will begin to flash.
6. Release the valet/program pushbutton switch. The parking lights will turn on for three
seconds to indicate that the learned tach signal is stored and the unit is out of the
tach learn mode.
NOTE: If the unit fails to learn tach rate due to an improper tachometer connection or
a poor tach source, the parking lights will not flash. To correct this situation,
locate and connect the Green/Orange Wire to the proper tach signal, and then
repeat the tach learn routine.
Page 12
128-9480
12 of 16