Electrode Setting; Turbulator Setting; Pump Connections And Port Identification - Riello Burners RIELLO 40 Series Installation & Operating Manual

Hide thumbs Also See for RIELLO 40 Series:

Installation, use and maintenance instructions (49 pages)

Table Of Contents

Table of Contents

A) Loosen NUT (1), and then turn SCREW (2) until the INDEX MARKER (3) is aligned with the correct

index number as per the Burner Setup charts, or OEM specifications given with the appliance.

B) Retighten the RETAINING NUT (1).

NOTE: OEM specifications take priority over retrofit

specifications shown in this manual.

MODEL F3 NOTE: Zero and four are scale indicators only

From left to right the first line is 3 and the last line 0.

MODEL F5: Same as above, except, scale indicators are 0

and 4.

PUMP CONNECTIONS AND PORT IDENTIFICATION

This burner is shipped with the oil pump set to operate on a single line system. To operate on a two-line system the by-

pass plug must be installed.

WARNING: Do not operate a single line system with the by-pass plug installed. Operating a single line system with the

by-pass plug installed will result in damage to the pump shaft seal.

NOTE: Pump pressure must be set at time of burner start-up. A pressure gauge is attached to the PRESSURE PORT (7)

for pressure readings. Two PIPE CONNECTORS (4) are supplied with the burner for connection to either a single or

two-line system. Also supplied are two ADAPTORS (3), two female ¼" NPT, to adapt oil lines to burner pipe

connectors. All pump port threads are British Parallel Thread design. Direct connection of NPT threads to the pump will

damage the pump body.

Riello manometers and vacuum gauges do not require any adapters, and can be safely connected to the pump ports. An

NPT (metric) adapter must be used when connecting other gauge models.

C6501000 F3-F5 I-O manual Rev4_3