Bosch TES 556 Series Instruction Manual page 41

2. Dismantle the milk frother into its indi-
vidual parts (6a to 6d) (see figure C at
the start of the operating instructions).
3. Clean the individual parts with a deter-
gent solution and a soft brush. If neces-
sary, soak in a warm detergent solution.
4. Rinse all parts with clear water and dry
them.
5. Reassemble all the parts and replace
fully in the appliance.
¡
Risk of scalding!
Use this appliance only after the milk frother
(6) has been fully assembled and installed.
Cleaning the brewing unit
Clean the brewing unit regularly!
To pre-clean the brewing unit automatically:
e
1. Select by turning the rotary knob (15).
2. Place an empty glass under outlet (6a).
3. Press the start button (10).
The appliance rinses.
In addition to the automatic cleaning
p rogramme, the brewing unit (5a) should be
removed regularly for cleaning. (See figure E
at the start of the operating instructions.)
1. Switch the appliance off at the power
on/off switch O / I (9). No buttons are lit.
2. Open the door (5b) to the brewing unit.
3. Slide the red lock (5e) on the brewing
unit (5a) completely to the left.
4. Press the eject lever (5d) down fully. The
brewing unit is released.
5. Grasp the brewing unit (5a) by the re-
cessed grips and remove carefully.
6. Remove the cover (5f) of the brewing
unit and rinse the brewing unit (5a)
t horoughly under running water.
7. Thoroughly clean the brewing unit sieve
under the running water.
en
37