Step 1; Step 2; Assembly Completion - modway Alyson MOD-6144 Manual

MOD - 6144, 6145

STEP 1:

Place Headboard (1) and Legs (2) on a carpeted or padded area as shown. Attach Legs (2) into Headboard (1) by inserting Flat Washer (B)
and JCBB 45mm Bolt (A) into the holes on the back of Legs (2) and Headboard (1). Tighten with M5 Allen key (C).
Ax4
Hardware & Tool required

STEP 2:

1. Line up the bed frame board's pre-drilled holes to match those of the headboard.
2. Secure the headboard to the bed frame by using JCBB bolt 60mm (E) for the thicker bed
frame, and JCBB bolt 45mm (D) for the thinner bed frame. Before inserting each bolt, place Spring washer (G) and Flat washer (F) on each bolt.
Then fit a Flat washer (F) on the screw as it protrudes through the other side of the bed frame.
3. Place a Hex nut (H) after the Flat washer (F) at the end of each screw. Then tighten by using the M5 Allen key (C) and hold the Hex nut (H)
by using Spanner (I).
4) Repeat the same procedure for each screw and each side of the bed frame.
Assembly is completed. The bed is ready to enjoy now!
Dx4 / Ex4 Fx8 Fx8
Hardware & Tool required
Customer Service 908-368-1025 www.modway.com
Bx4 Cx1
Gx4
12.8 12.8
Hx4 Hx4 Ix1 Ix1
The headboard's height can be adjusted
minimum 1110mm to maximum 1410mm
from headboard to floor level.
Cx1 Cx1
Page 2/2