Recovery - Pilz PCOM sec br2 Operating Manual

Operation
Setup
Colour
- - -
Green
I0
Colour
- - -
Green
O0
Colour
- - -
Green
TRF
Colour
- - -
Yellow
LNK
Colour
- - -
Green
11.2

Recovery

If you experience problems with the configuration, a failed firmware update or any other
situation in which the system is no longer functional, it may be necessary to reset the sys-
tem.
Typical problems that require a system reset:
}
Interrupting the supply voltage during the firmware update
}
Forgotten password
}
Incorrect configuration of the IP address
}
All the data must be deleted, when the SecurityBridge is to be decommissioned for ex-
ample (see operating instructions, Section
operation [
Operating Manual PCOM sec br2
1004534-EN-04
State
State
State
State
State
41]).
Meaning
Setup mode is deactivated
Device is in setup mode
Meaning
No signal at the input
There is a 1 signal at the input
Meaning
No signal at the output
There is a 1 signal at the output
Meaning
No data traffic
Data traffic present
Meaning
No network connection
Network connection exists
Take SecurityBridge safely out of
| 39