Chapter 8 Installing A Cascaded System; Install A Cascaded System; Cli Commands For Cascaded Systems; Topology-Related Parameters For Redundant Topologies - Cisco SCE 2000 Quick Start Manual

Installing a Cascaded System
This section outlines the installation procedures for a redundant solution with two cascaded SCE 2000s.
For more complete information,refer to the Cisco SCE 2000 4xGBE Installation and Configuration
Guide . Refer to the Cisco SCE 2000 4xGBE CLI Command Reference for details of the CLI commands .
When working with two SCE 2000s with split-flow and redundancy, it is extremely important to follow
this installation procedure.
To install a cascaded system, complete the following steps:
•
•
•
•

Install a Cascaded System

•
•

CLI Commands for Cascaded Systems

This section presents CLI commands relevant to the configuration and monitoring of a redundant system.
Use the following commands to configure and monitor a redundant system:

Topology-Related Parameters for Redundant Topologies

All four of the topology-related parameters are required when configuring a redundant topology.
•
OL-7820-06
Install a Cascaded System
Configuring the Connection Mode
Link Mode
How to Monitor the System
CLI Commands for Cascaded Systems
Topology-Related Parameters for Redundant Topologies
connection-mode
[no] force failure-condition
Show interface linecard 'number' connection-mode
Show interface linecard 'number' physically-connected links
Connection mode — Redundancy is achieved by cascading two SCE platforms. Therefore the
connection mode for both SCE platforms may be either:
Inline-cascade
–
8
C H A P T E R
Cisco SCE 2000 4xGBE Quick Start Guide
8-1