Example - Cisco SCE 2000 Quick Start Manual

Perform the Initial System Configuration
The local time and date are displayed, and you are asked whether you want to change them
The local time and date is 15:00:01 CET FRI 01 July 2002
Would you like to set a new time and date? [no]:
•
•
Enter the SNTP configuration menu.
Step 5
If you do not wish to configure the SNTP, skip the rest of this section and go to .
To enter the SNTP configuration dialog, type y , and press Enter
Would you like to enter the SNTP configuration menu? [no]: y
Configure the SNTP broadcast client. By default the SNTP broadcast client is not enabled.
Step 6
•
•
•
Step 7 Define the time interval between unicast updates.
•
Specify an IP address for the SNTP unicast server.
Step 8
Type in the hostname or the IP address in the form x.x.x.x , and press Enter
Would you like to configure SNTP unicast servers? [no]: y
Enter IP address or hostname of SNTP unicast server: 10.1.1.1

EXAMPLE:

Following is a sample time setting dialog. In addition to setting the time zone, time and date are changed,
and SNTP unicast updates are configured.
Would you like to enter the Time settings menu? [no]: y
Enter time zone name [UTC]: ISR
Enter time zone minutes offset from UTC: 120
The local time and date is 15:35:23 ISR FRI July 19 2002
Would you like to set a new time and date? [no]: y
This change will take effect immediately both on the system clock
and the calendar; it will also set the time zone you entered.
Are you sure? [yes/no]: y
Enter new local time and date: 14:35:23 19 July 2002
Time zone was successfully set.
The system clock and the calendar were successfully set.
Would you like to enter the SNTP configuration menu? [no]: y
Enable SNTP broadcast client? [no]: y
Enter time interval in seconds between unicast updates [900]:
Would you like to configure SNTP unicast servers? [no]: y
Enter IP address or hostname of SNTP unicast server: 10.1.1.1
Cisco SCE 2000 4xGBE Quick Start Guide
4-10
If the time and date are correct, press Enter and go to Step 5.
If the time and date are not correct, answer yes to the above question, and press Enter.
Would you like to set a new time and date? [no]: y
Confirm your response and type the new time and date.
This change will take effect immediately both on the system clock and calendar;
it will also set the time zone you entered. Are you sure? [yes/no]: y
Enter new local time and date: 14:00:01 1 July 2002
Time zone was successfully set.
The system clock and the calendar were successfully set.
To disable the SNTP broadcast client, press Enter.
To enable the SNTP broadcast client, type y and press Enter.
Enable SNTP broadcast client? [no]:
To accept the displayed default value, press Enter.
Enter time interval in seconds between unicast updates [1024]:
Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
OL-7820-06