Cisco SCE 2000 Quick Start Manual page 25

Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
Table 4-1
Parameter
Access Control List number
list entries (maximum 20 per list)
IP access ACL
telnet ACL
SNMP agent status
GET community names
SET community names
trap managers (maximum 20)
Authentication Failure trap status
enterprise traps status
system administrator
Topology Configuration
connection mode
type of deployment
physically connected link
(cascade topology only)
priority
(cascade topology only)
OL-7820-06
Setup Command Parameters (continued)
Perform the Initial System Configuration
Definition
How many ACLs will be necessary? What IP
addresses will be permitted/denied access for each
management interface? You may want ACLs for
the following:
Any IP access
•
Telnet access
•
SNMP GET access
•
SNMP SET access
•
IP address, and whether permitted or denied
access.
ID number of the ACL controlling IP access.
ID number of the ACL controlling telnet access.
Enable or disable SNMP management.
Community strings to allow GET access and
associated ACLs (maximum 20).
Community strings to allow SET access and
associated ACLs (maximum 20).
Trap manager IP address, community string, and
SNMP version.
Sets the status of the Authentication Failure traps.
Sets the status of the enterprise traps.
Name of the system administrator.
Is the SCE 2000 installed using inline topology or
receive-only topology using an optical splitter?
Is this a cascade topology, with two SCE 2000 s
connected via the cascade ports? Or is this a single
platform topology?
In a cascade deployment this parameter sets the
index for the link that this SCE 2000 is deployed
on. The options for SCE 2000 are link-0 or link-1.
In a single- SCE 2000 Platform deployment this
parameter is not relevant since one SCE 2000 is
deployed on both links. In this case the link
connected to port1-port2 is by default link-0 and
the link connected to port3-port4 is be default
link-1.
If this is a cascaded topology, is this SCE 2000 the
primary or secondary SCE 2000 ?
Cisco SCE 2000 4xGBE Quick Start Guide
4-5