Cisco SCE 2000 Quick Start Manual page 38

Perform the Initial System Configuration
The maximum number of GET communities is 20.
To add more entries, type y and press Enter
1.
Would you like to add another SNMP GET community? [no]: y
Enter up to 20 SNMP GET communities as described in step 3.
2. When all entries have been added, press Enter
Would you like to add another SNMP GET community? [no]:
Step 5 Configure the SNMP SET community.
1. Type the SNMP SET community name and press Enter.
The SNMP agent that resides inside the SCE 2000 will respond only to SET requests that use this
community string.
Enter SNMP SET community name:
Note that there is no default for this parameter.
Assign an access list to restrict the SNMP management stations that may use this SET community.
2.
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use '0' to allow
all:
Configure additional SET communities.
Step 6
The maximum number of SET communities is 20.
To add more entries, type
1.
Would you like to add another SNMP SET community? [no]:y
2. Enter up to 20 SNMP SET communities as described in step 5.
3. When all entries have been added, press Enter
Would you like to add another SNMP SET community? [no]:
Step 7 Configure the SNMP trap managers.
Enter the SNMP trap managers menu.
1.
Would you like to configure SNMP trap managers? [no]: y
Type y and press Enter.
2.
The SNMP trap managers dialog begins.
If you choose not to configure SNMP trap managers, the dialog skips to the authentication failure
trap status. (See step 9.)
Type the trap manager IP address and press Enter.
3.
Enter SNMP trap manager IP address:
Note that there is no default for this parameter.
4. Type the trap manager community string and press Enter.
Enter SNMP trap manager community string:
Note that there is no default for this parameter.
Type the number of the trap manager SNMP version (1 or 2c) and press Enter.
5.
Cisco SCE 2000 4xGBE Quick Start Guide
4-18
Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
and press Enter
y
OL-7820-06