Connect The Ac-Input Power Supply Unit - Cisco SCE 2000 Quick Start Manual

Connecting the Power
Look at the IN and OK LEDs on the power supply unit and the corresponding Power LED on the front
Step 7
panel. If the DC-input power supply unit is operating properly, these LEDs will be glowing green.
Ensure that the power supply is properly aligned and the installation screw is tightened.
Step 8

Connect the AC-Input Power Supply Unit

Plug the AC-input power cable into the AC-input power receptacle on the AC-input power supply
Step 1
For AC-input power, we recommend powering the SCE 2000 platform from a 120 VAC, 15A receptacle
U.S. (240 VAC, 10A international) at the power source.
Figure 3-4
BY PA SS
2
BY PA SS
IN
PO W ER B
Step 2 Plug the AC power supply cable into the AC power source.
Step 3 Turn the on/off switch to the on position.
Look at the IN and OK LEDs on the power supply unit and the corresponding Power LED on the front
Step 4
panel. If the AC-input power supply unit is operating properly, these LEDs will be glowing green.
Step 5 Ensure that the power supply is properly aligned and the installation screw is tightened.
Cisco SCE 2000 4xGBE Quick Start Guide
3-4
Connecting the AC Power
1
OK
IN
PO W ER A
OK
Chapter 3 Connect the Power Supply Units
OL-7820-06