Chapter 5 Cable The Line Ports; Information About Cabling; Single Link: Inline Topology - Cisco SCE 2000 Quick Start Manual

Cable the Line Ports
This section provides instructions for cabling the Gigabit Ethernet ports for both one and two SCE 2000
topologies, and for configuring Gigabit Ethernet (GBE) interface parameters. In a topology utilizing two
SCE 2000s (cascade), this includes the cascade ports as well as the line ports.
Class 1 laser. Avoid exposure to radiation and do not stare into open aperture.
When installing a cascaded system, it is extremely important to follow the sequence of procedures
Note
outlined in the section
•
•
•

Information About Cabling

When installing a cascaded system, it is extremely important to follow the sequence of procedures
Note
outlined in the section Installing a Cascaded System.
•
•
•
•

Single Link: Inline Topology

In the inline topology, the SCE 2000 resides physically on the GBE (Gigabit Ethernet) link between the
subscribers, which are usually connected through either a BRAS (in DSL access), a PDSN (in wireless
access), a CMTS (in the Cable access), or a switch or router aggregator (in other topologies), and the
network, where the SCE 2000 usually connects to a router or layer 3 switch network element.
OL-7820-06
Installing a Cascaded
Information About Cabling
Configuring GigabitEthernet Auto-Negotiation
Connect the GBE Line Interface Ports
Single Link: Inline Topology
Single Link: Receive-only Topology
Dual Link: Single SCE 2000 Topologies
Dual Link: Two SCE 2000s Topology
C H A P T E R
System.
Cisco SCE 2000 4xGBE Quick Start Guide
5
5-1