Table of Contents
Advertisement
Step 3 – Mounting the receiver
TM
No matter which XtremeLink
receiver you use, the mounting procedure is
the same. The most important thing to remember is that you must keep the
antenna portion of receiver no less than 2 inches from anything that is
metallic. This includes steel, carbon fiber, servos, fuel pumps, any type of
wiring, etc.
The best method of mounting is to show it off!
Keep the
receiver separated from anything else, and mount it out in the open so you
can easily see it and get access to it (see Figures 5 & 6 for examples).
Under no circumstance can you wrap or pass servo wires around the
antenna! See figures 5 and 6 for reference.
Antenna orientation does not matter, so you are free to mount the receiver
at any angle you like as long as you keep the antenna separated from
anything metallic.
TM
Figure 5 – XtremeLink
8 channel receiver installation
8
Advertisement
Table of Contents
