Table of Contents
Advertisement
SET OUTPUT TYPE
Range: N/A
This function is not currently supported.
It will be supported in future
versions to allow different servo output types such as sequential, grouped,
TruDigital™, etc.
SET FAILSAFE TIME
Range: 1 to 5 seconds
The failsafe time is the number of seconds before the receiver will go into
failsafe mode.
With LED flashing green, press and HOLD the PROG button until the LED
turns off. The LED will now slowly flash green the number of times equal to
the current failsafe time (in seconds). For example, the default failsafe time
is 2, so the LED will flash 2 times.
After the flashing stops you have 5 seconds to change the power level. To
change the power level, press and release the PROG button one time for
each additional second you would like the failsafe time to be. For example,
if you wanted the failsafe time to be 1 second, you would press and release
the PROG button once. If you wanted the failsafe time to be 3 seconds, you
would press and release the button 3 times.
If you do not press the PROG button within 5 seconds, or if the value you
enter exceeds what is allowed, the LED will alternately flash red and green
(error condition occurred) and no change will be made. At this point, you
are back at the programming mode start.
If you do make a change, the LED will blink green/red/orange in rapid
succession to let you know that the change was successful.
17
Advertisement
Table of Contents
