Table of Contents
Advertisement
SET POWER LEVEL
Range: 1 to 5
With LED solid red, press and HOLD the PROG button until the LED turns off.
The LED will now slowly flash green the number of times equal to the current
power setting. For example, the default power level is 5, so the LED will
flash 5 times.
After the flashing stops you have 5 seconds to change the power level. To
change the power level, press and release the PROG button one time for
each level of power you would like. For example, if you wanted the power
level to be the lowest possible value, you would press and release the PROG
button once. If you wanted the power level to be 3, you would press and
release the button 3 times.
If you do not press the PROG button within 5 seconds, or if the value you
enter exceeds what is allowed, the LED will alternately flash red and green
(error condition occurred) and no change will be made. At this point, you
are back at the programming mode start.
If you do make a change, the LED will blink green/red/orange in rapid
succession to let you know that the change was successful.
Power output can be calculated as 10mw + (10mw x Power Level).
following power levels must be adhered to in order to legally use this
product:
Country
USA / U.K.
Australia
Japan
Europe
Allowable setting
1-5
1-5
1 only
Varies, consult local laws
11
The
Advertisement
Table of Contents
