Table of Contents
Advertisement
If you do not press the PROG button within 5 seconds, or if the value you
enter exceeds what is allowed, the LED will alternately flash red and green
(error condition occurred) and no change will be made. At this point, you
are back at the programming mode start.
If you do make a change, the LED will blink green/red/orange in rapid
succession to let you know that the change was successful.
The country selection is necessary to meet various FCC, ETSI, IC, and other
guidelines.
Country
USA / U.K.
France
Japan
Europe
SET BINDING
Range: N/A
This function is used to "marry" or "bind" the XtremeLink
TM
XtremeLink
RF Module. You can have as many receivers as you like bound
to a single transmitter.
Please see section 4 for information on how to bind the XtremeLink™
system.
Setting
1
2
3
4
16
TM
receiver with an
Advertisement
Table of Contents
