Xtreme Power Systems XtremeLink Installation And Usage Manual page 19

Hide thumbs Also See for XtremeLink:
Table of Contents

Advertisement

Setting the Failsafe
If no failsafe is programmed, the servos will hold their last known valid state
when a failsafe condition occurs.
You can program the failsafe position for each channel. To do this, turn on
the XtremeLink™ system so that servos can be moved. Now, press and hold
the programming button on the XtremeLink™ receiver until the STATUS LED
goes out. The STATUS LED will begin alternately flashing red and green for
about 8 seconds.
During this time, move your sticks and switches to the
where you would like them during a failsafe condition.
19

Advertisement

Table of Contents
loading

Related Products for Xtreme Power Systems XtremeLink

Table of Contents