Table of Contents
Advertisement
SECTION 2 – TRANSMITTER MODULE
After turning on your transmitter, the STATUS LED on the XtremeLink
module will flash RED.
TM
XtremeLink
receiver.
When a connection is established, the STATUS LED will light solid green. If
there are telemetry sensors attached to the receiver, the STATUS indicator
will flash orange every time telemetry data is received
Programming Features
By holding the PROG (program) button on the RF module while turning on
the power to the transmitter, you can enter "programming mode".
mode allows various features to be changed, and also is required for binding
TM
the XtremeLink
Once you are in programming mode, the STATUS LED will be solid red. Each
time you press and release the PROG button, the STATUS LED will change.
Below is a table of STATUS LED colors and their meanings:
STATUS LED
Solid Red
Solid Green
Solid Orange
If you press and HOLD the PROG button while the LED is any one of these
colors, the LED will turn off and you will enter the programming for that
function. For example, if you wanted to bind the transmitter module to a
receiver, you would briefly press and release the PROG button until the LED
was orange. Then you would press and HOLD the PROG button until the LED
turns off, at which point you would then see the LED flashing orange (in
binding mode).
This means that there is no connection to an
RF module to an XtremeLink
TM
receiver.
FUNCTION
Set Power Level
Set Modulation
Set Binding
10
TM
RF
This
Advertisement
Table of Contents
