Table of Contents
Advertisement
SECTION 3 – RECEIVER
After powering on your receiver, the STATUS LED on the receiver will flash
RED. This means that there is no connection to an XtremeLink
(plugged into your transmitter).
When a connection is established, the STATUS LED will light solid green.
Programming Features
To enter programming mode, any transmitter module that has been "bound"
to the receiver must be turned off prior to powering on the receiver.
Once the STATUS LED is flashing red, briefly press and release the
programming button on the XtremeLink™ receiver. This will put receiver in
"programming mode". NOTE: The receiver's programming button is located
on the circuit board itself and can be depressed using a 3/32 Allen key or
similar BLUNT object. DO NOT USE ANY TYPE OF SCREWDRIVER to press
the button or damage will result! See Figure 7 for hole location.
Once you are in programming mode, the STATUS LED will be solid red. Each
time you press and release the PROG button, the STATUS LED will change,
indicating a different programming function. Below is a table of STATUS LED
colors and their meanings:
STATUS LED
Solid Red
Solid Green
Solid Orange
Blinking Red
Blinking Green
Blinking Orange
FUNCTION
1 - Set Channel Map
2 - Set Country
3 - Set Binding
4 - Set Output Type
5 - Set Failsafe Time
6 - Telemetry mode
13
TM
RF module
Advertisement
Table of Contents
