Table of Contents
Advertisement
With STATUS LED solid red, press and HOLD the PROG button until the
STATUS LED turns off. The STATUS LED will now flash orange the number
of times equal to the current output channel position, followed by a 1 second
pause. When you first enter the channel map programming (channel 1), the
STATUS LED will flash once, followed by a 1 second pause.
Every time you press and release the PROG button, the channel map
position will advance by 1. The channel map position begins at 1 (1 flash)
and ends with the number of channels that your receiver has.
So, the 8
TM
channel XtremeLink
has 8 possible channel map positions, while the 10
TM
channel XtremeLink
receiver has 10 possible channel map positions.
To change the channel map output, press and HOLD the PROG button until
the STATUS LED turns off. The STATUS LED will begin flashing green the
number of times equal to the current map position output. For example, the
default value of the channel map 1 would flash just once. After the STATUS
LED is done flashing green, you have 5 seconds to enter a new map position
value. You do this by pressing and releasing the PROG button the number of
times equal to the new map position.
If you do not press the PROG button within 5 seconds, or if the value you
enter exceeds what is allowed, the LED will alternately flash red and green
(error condition occurred) and no change will be made. At this point, you
are back at the channel map position.
If you do make a change, the LED will blink green/red/orange in rapid
succession to let you know that the change was successful.
SET COUNTRY
Range: 1 to 4
With LED solid green, press and HOLD the PROG button until the LED turns
off. The LED will now slowly flash green the number of times equal to the
current country setting. For example, the default country level is 1, so the
LED will flash 1 time.
After the flashing stops you have 5 seconds to change the country.
To
change the country, press and release the PROG button the number of times
necessary to equal the country from the list below. For example, if you
wanted the country to be Japan, you would press and release the PROG
button three times.
15
Advertisement
Table of Contents
