Table of Contents
Advertisement
TM
Step 2 – Installing the XtremeLink
RF Module
TM
Position the XtremeLink
RF module over the original RF module location,
and slowly press the module into the transmitter case. There should be no
excessive force required to install the module. When the module is properly
installed, it will "snap" into place and sit flush with the back of the
transmitter case.
See figures 3 and 4 for reference.
The stock metal transmitter antenna MUST be removed.
Nearly all
transmitter antennas simply unscrew. If your transmitter has a pivot ball on
top that the antenna normally screws into, do not screw in the antenna
TM
when the XtremeLink
RF module is installed.
If you switch back to a stock RF module, remember to re-install the
antenna or damage may result to the transmitter!
TM
When using the XtremeLink
RF module, the transmitter's modulation
output must be set to PPM, MPLX, PPM18, or PPM24. PCM, APCM, SPCM,
PCM1024, PCM2048, or any other method of modulation is not currently
supported. This may change in the future. You will know if the modulation
output is correct or not by looking at the STATUS LED when the power is
turned on. If the LED lights up orange and does not change, the transmitter
modulation is not set correctly.
If the STATUS LED flashes red, then the
transmitter modulation is set correctly.
5
Advertisement
Table of Contents
