Table of Contents
Advertisement
Network Stack Configuration
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unified Extensible
Firmware Interface) for network stack support. The options are Enabled and Disabled.
*If the feature above is set to Enabled, the next six features will be available for
configuration:
Ipv4 PXE Support
Select Enabled to enable IPv4 PXE boot support. The options are Disabled and Enabled.
Ipv4 HTTP Support
Select Enabled to enable IPv4 HTTP boot support. The options are Disabled and Enabled.
Ipv6 PXE Support
Select Enabled to enable IPv6 PXE boot support. The options are Disabled and Enabled.
Ipv6 HTTP Support
Select Enabled to enable IPv6 HTTP boot support. The options are Disabled and Enabled.
PXE Boot Wait Time
Use this option to specify the wait time to press the ESC key to abort the PXE boot. Press
"+" or "-" on your keyboard to change the value. The default setting is 0.
Media Detect Count
Use this option to specify the number of times media will be checked. Press "+" or "-" on
your keyboard to change the value. The default setting is 1.
Super IO Configuration
Super IO Chip AST2500
Serial Port 1 Configuration
Serial Port 1
Select Enabled to enable the onboard serial port specified by the user. The options are
Enabled and Disabled. Enable this feature for the next two features to display and only
the Change Settings feature is available for configuration.
Device Settings
This feature displays the base I/O port address and the Interrupt Request address of a
serial port specified by the user.
69
Chapter 5: UEFI BIOS
Advertisement
Table of Contents
