Würth MIG 350 SYN Translation Of The Original Operating Instructions page 14

Front and back panel (MIG 350 SYN)
1. Socket (＋): Connecting Welding cable to wire
feeder.
2. Control socket for wire feeder.
3. Socket ( - ): Connecting earth cable to work-piece.
4. Control Panel GUI: Status display, function
selection and welding parameters, when welding
the actual current and voltage display, and so on.
5. Air auto switch: When the machine overload or
power off suddenly, it is can protect the machine.
6. Cable fixed head, 3phase XXXV/50Hz.
7. Nameplate
8. Fan
14
Operation
Front and back panel (MIG 500 SYN)
1. Socket （＋）: Connecting Welding cable to
wire feeder.
2. Control socket for wire feeder
3. Control Panel GUI: Status display, function
selection and welding parameters, when welding
the actual current and voltage display, and so on
4. Cable fixed head ,3phase XXXV/50HZ
5. Heat power socket（AC36V）:connecting heater
coil of CO2 gas regulator
6. Power fuse(3A) , High voltage, when changed
should be cutting the power
7. Air auto switch: When the machine overload or
power off suddenly, it is can protect the machine
8. Nameplate
9. Socket ( - ): Connecting earth cable to work-
piece.
10. Fan
11. Hoop
12. The tank outlet