Boiler Location - NTI Triton VS80-130 Assembly, Installation And Operation Instructions

│
Triton
Installation and Operation Instructions - Boiler Location

3.0 BOILER LOCATION

In all cases, the Triton must be installed indoors in a dry location where the ambient temperature must be
maintained above freezing and below 100F [38C]. All boiler components must be protected from dripping,
spraying water, or rain during operation and servicing. Consider the proximity to the following when
determining the best boiler location.
 System Water Piping
 Oil Supply
 Electrical Power
 Combustion Air / Ventilation Air
 Chimney
Components - Water or flood damaged components must be replaced immediately with
new components (see parts list). Failure to do so may result in fire, serious injury, or death.
Clearances - Clearances to combustibles represent the minimum clearances required for safety and service.
Recommended clearances are for ease of piping installation, annual maintenance, and service access. Refer to
Table 3-1 and Figure 3-1.
Table 3-1 Minimum Clearances for Installation and Service
Clearances
Front
To Combustibles 24 [610]
Recommended 36 [915]
Notes:
1
Minimum clearances from flue pipe to combustibles is 9" for single-wall pipe; 6" for double-wall pipe (Type-L).
2
Flue pipe clearances take precedence over all other clearances.
Boiler Location - Even if all installation codes are met, good judgment and common
sense must also be used when selecting a boiler location. Refer to minimum clearances in
Table 3-1 and vent clearances for chimney or direct vent applications.
Flue Pipe, 9" minimum
Flue pipe clearances
take precedence over
all clearances; refer to
Table 3-1.
6
Rear Top
5 [124] 24 [610]
24 [610] 24 [610]
Figure 3-1 Minimum Clearances to Combustibles
Rear 5"
Front 24"
Dimensions - inches [mm]
Right Side Coil Side
5 [124] 24 [610]
24 [610] 24 [610]
Coil Side 24"
VS80-130
1, 2
Flue Pipe Floor
9 [228] Non-combustible
9 [228] Non-combustible
Top 24"
Right Side 5"