Configure A Telnet Session; Set The Enable Security Mode Password; Save The Configuration; Complete The Installation - ADTRAN NetVanta Series Quick Configuration Manual

Configure a Telnet Session

The following steps show how to access the Telnet configuration parameters and change the
password. The default password for initializing a Telnet session is password (all lowercase). For
security purposes, change the password to something unique. For this example, replace the
underlined word with a password of your choosing. The NetVanta supports five Telnet sessions
(0 through 4).
1. Verify that the prompt of your unit displays (config)#.
2. Enter line telnet 0 4 to change the configuration parameters for the Telnet session.
3. Enter password word to change the login password for the Telnet session.
4. Enter exit to return to the Global Configuration mode.
An enable security mode password must be defined before configured Telnet sessions are
activated. See Set the Enable Security Mode Password for information on password
configuration.

Set the Enable Security Mode Password

1. Verify that the prompt of your unit displays (config)#.
2. Enter enable password word to set the Enable Security mode password.
or
3. Enter enable password md5 word to encrypt the enable password using MD5 encryption.
The Enable Security mode passwords are case sensitive.

Save the Configuration

1. Verify that the prompt of your unit displays (config)#.
2. Enter exit to leave configuration mode.
3. Enter copy running-config startup-config to save the current configuration to memory. This
command may be abbreviated as copy run start.
4. Enter exit to close the configuration session.

Complete the Installation

The NetVanta is now configured and operational. Complete the installation by connecting the
appropriate cables to the networks. Please refer to the NetVanta Hardware Installation Guide for
details on pinouts and cabling.
4 Technical Support 1-888-4ADTRAN (1-888-423-8726) 64200867L1-42B