Table of Contents
Advertisement
SPN850 Spin Bike
Adjusting Suspension
For a more comfortable "ride", the equipment features adjustable rear suspension.
Rotate the nut (3) at the top of the suspension unit as required. Rotate right to
harden the suspension (for heavier riders), rotate left to soften.
Adjusting the Saddle
For a more comfortable "ride" and to suit riders of different sizes, the
equipment features multiple saddle adjustments, including height, angle and
distance from the handlebar.
•
To adjust height, loosen (rotate left) the seat post knob (4) a little, then
pull it out so that the pin in the knob disengages from the locating hole
(5) in the seat post. Keep the knob pulled out then slide the seat post to
the required position. Release the knob and ensure the pin engages with
a hole in the seat post (it may be necessary to slide the post somewhat
until the pin "pops" into a hole). Firmly tighten the knob by hand.
•
To adjust angle, loosen (rotate left) the saddle clamp nuts (6) until the
front of the saddle can be moved up/down. Set the angle as required,
then tighten the nuts securely.
•
To adjust distance to the handlebar, loosen (rotate left) the saddle nut
(7), then slide the saddle base (8) to the required position. For further
adjustment, remove the saddle base from the seat post and rotate it
180° then re-install and adjust the saddle position as required.
Maintenance and Troubleshooting
Cleaning and Storage
•
The equipment can be cleaned with a soft cloth and mild detergent. Do not use abrasives or solvents. Be
careful not to get excessive moisture on the console as this may damage it.
•
After each use, wipe the unit of any sweat, dirt or liquids.
•
Keep the equipment, especially the console, out of direct sunlight to prevent damage.
•
Store the equipment in a clean and dry indoor environment. Never leave or use the unit outdoors.
Troubleshooting
Problem
Riding difficult.
No console display.
Ride harsh.
When to Call for Help
This equipment is designed with user safety as a priority. If after you check the equipment and possible
adjustments that it is still not operational, call an authorized service centre or technician for servicing.
E&OE
Potential Reason
Effort brake over-adjusted.
No connection.
Suspension too hard.
© 2017 Proflex
5
8
Correction
Reduce effort – rotate adjuster left.
Check batteries are serviceable and electrical
cables are in good condition and properly
connected.
Soften ride – rotate adjuster left.
3
4
7
6
9
Advertisement
Table of Contents
