Proflex SPN850 User Manual page 7

SPN850 Spin Bike
F
12. Slide the console (18) onto the mounting tab (H) on the top of the handlebar post shroud. Plug in the
"pulse" sensor connector (I) (from the handlebar) and the bike "sensor" connector (J) into the PULSE
and SENSOR connectors on the rear of the console, respectively. Use the cable tubing (19) to help tidy
the wiring, if desired.
The machine should resemble the image below and is ready for use.
Moving
The unit can be tilted onto its wheels for easy moving.
Firmly grasp the handlebar with both hands. Next, carefully
tilt the equipment forward until it rolls freely on the transport
wheels.
E&OE
18
J
H
Always set-up the equipment on a
flat and level surface. If the
equipment "rocks", rotate the adjusters under
the feet to lift or lower as needed so the
equipment is steady.
© 2017 Proflex
17
I
G
19
7