Operation; Console And Functions; Adjusting Effort; Adjusting The Handlebar - Proflex SPN850 User Manual

Spin bike
Table of Contents

Advertisement

SPN850 Spin Bike

Operation

Console and Functions

The equipment features a display that provides you with workout
information, such as duration, speed, distance travelled etc.
Whenever the console is activated, a new "session" starts, with all
values at "zero". If the equipment is not being used and the console
is not touched (buttons pressed), it will automatically switch off after
approximately 4 minutes. To activate the console, press any button
or start riding.
Control
Description
Display
Shows current information, such as speed, time, pulse etc.
Function
Press to switch between display modes. Press and hold for several seconds to reset all
Button
values (except odometer) to "0" (zero):
Scan – Automatically switch between display modes approximately every 5 seconds.
When in this mode, "SCAN" shows along the bottom of the display.
Time – Current elapsed time of the session in minutes (limits 0 to 99.59). When in this
mode, "TIME" shows along the bottom of the display.
Speed – Current speed in km/h (limits 0 to 99.9). When in this mode, "SPD" shows along
the bottom of the display.
Distance – Current distance travelled during the session (limits 0 to 999.9). The distance
value increments every 100 meters travelled. When in this mode, "DST" shows along the
bottom of the display.
Calories – The number of calories used during the current session (limits 0 to 9999). To
approximately convert calories to kilojoules, multiply the number of calories by 4. When in
this mode, "CAL" shows along the bottom of the display.
Odometer – The total distance travelled for the current and all previous sessions
combined. This value cannot be reset, however, will return to "0" if the batteries are
replaced. When in this mode, "ODO" shows along the bottom of the display.
Pulse – Your current pulse (heart rate) (limits 40 to 240). When displaying pulse, you
must have a hand on the metal sensors on each handle. The console must have the pulse
sensor connected and have 2 batteries installed. When in this mode, "PULSE" shows
along the bottom of the display.

Adjusting Effort

The equipment allows you to adjust the effort required to turn the wheel by "braking" the
wheel. The greater the effort, the larger the amount of energy (calories) required to "ride".
To adjust effort, rotate the adjuster (1) on the main frame tube as required to either
increase (rotate right) or decrease (rotate left) effort.
The braking adjuster also acts as an emergency stop – press down firmly and hold to quickly stop
the flywheel.

Adjusting the Handlebar

The equipment features a height adjustable handlebar. Loosen (rotate left) the handlebar
locking handle (2) then slide the handlebar up/down as required, then firmly tighten the
locking handle by hand.
E&OE
© 2017 Proflex
1
2
8

Advertisement

Table of Contents
loading

Table of Contents