TATA Motors NEXON BSVI 2021 Owner's Manual page 148

Table of Contents

Advertisement

safely.
Reverse Park Assist feature works on ultra
sound echo technology, due to which per-
formance is not guaranteed in following
scenarios:
If the object has a sharp edge surface,
where surface may divert echoes from
sensor reception.
If object is mesh fence made up of thin
wires, where echoes can't be given by
the surface.
Fast moving objects passes in the sen-
sor's field of detection, where echoes
are not processed by the system.
If object is made/covered by foam or
sponge or snow where ultrasonic
sound signals are absorbed.
Objects close to the rear bumper can
go undetected by the Reverse Park
Assist's field of detection. Driver
should use extreme caution while
parking the vehicle.
If height of the bumper is changed due
to alteration to the suspension or other
causes.
If the sensor areas are extremely hot
from direct sunlight or cold due to
freezing weather.
If Sensors are covered by a hand,
sticker, accessory, etc.
If ultrasonic noise is present around
Vehicle due to other vehicle sensors,
horn, engine, air braking sys-tem
(large vehicles), Exhaust Fans, Wire-
less transmitters or mobile phones.
If the vehicle speed exceeds 10kmph,
the system will not warn you even
though objects are detected, error
message 'Vehicle Speed is high, drive
slowly!' will appear.
Driving on uneven road surfaces e.g.
Gravel, unpaved roads, Artificial Speed
Breakers, or gradient.
Poles of square/rectangular cross sec-
tion might not be detected due to the
ultrasonic technology limitation.
WARNING
Due to any reason, if the sensor gets
misaligned or loses its intended fitment
STARTING AND DRIVING
position, contact your dealer for refit-
ment.
NOTE
Turning the ignition 'OFF' 'while the park
assist feature is active would disable it.
139

Advertisement

Table of Contents
loading

Table of Contents