9.7.14 Burner Control Ignition
The Pilot test hold function allows the installer to set
22, without turning on the Main valve. With a call for
heat enabled the unit will start the normal sequence of
operation to light the pilot only. Once pilot pressure has
been properly set, the installer must disable call for heat
is supplied the unit will light normally.
The installer can set the control to display
temperature units in °F or °C, can adjust the anti
off inhibit time, and can set the time allowed for an
alarm to sound before being silenced.
The outdoor temperature can be read from the
outdoor sensor that is shipped with the Unit, or from
an Envirocom outdoor sensor (sold separately). The
tell the control which sensor is being used.
Page 65