Troubleshooting - AEG EOD3460AA User Manual

When the cleaning is completed, install the
glass panels and the door. Do the above
steps in the opposite sequence. Install the
smaller panel first, then the larger.
10.6 Replacing the lamp
Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
You cannot activate or op-
erate the oven. The display
shows "400" and an acous-
tic signal sounds.
The oven does not heat up. The oven is deactivated.
The oven does not heat up. The clock is not set.
The oven does not heat up. The necessary settings are
The oven does not heat up. The fuse is blown.
The lamp does not operate. The lamp is defective.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "12.00". There was a power cut.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
The back lamp
1. Turn the lamp glass cover
2. Clean the glass cover.
3. Replace the oven lamp with a suitable
4. Install the glass cover.
Possible cause
The oven is incorrectly con-
nected to an electrical sup-
ply.
not set.
You left the dish in the oven
for too long.
or deactivate the circuit breaker.
The lamp glass cover is at the
back of the cavity.
counterclockwise to remove it.
300 °C heat-resistant oven lamp.
Use the same oven lamp type.
Remedy
Check if the oven is correct-
ly connected to the electri-
cal supply (refer to the con-
nection diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing process ends.
Reset the clock.
ENGLISH 19