Ac Power; Overead Mounting - PROEL Four Rays Rainbow User Manual

AC POWER

Before operation ensure that factory setting of voltage and frequency match local power
supply.
Always ground (earth) the fixture electrically.
Use only a source of AC power that complies with local building and electrical codes and
has both overload and ground-fault protection.
If it is necessary to substitute power supply plug, connect it in accordance with the
following code:
GREEN/YELLOW: Ground
BLUE: Neutral
BROWN: Live
WARNING: the luminaire must be earthed
Connect the mains power cable to the fixture at the 3-prong IEC male input socket at the
rear of the fixture.
OVERHEAD MOUNTING
PLLAS105X4 is designed to be hung overhead with a clamp (not included).
Warning! Block access below the work area before proceeding.
Always use a secure means of secondary attachment (safety rope).
Verify that the structure can support at least 10 times the weight of all installed fixtures,
clamps, cables, auxiliary equipment, and other items.
If hanging the fixture with a rigging clamp, verify that the clamp is undamaged and is
designed for the fixture's weight. Bolt the clamp securely to the mounting bracket on the
fixture with a grade 8.8 (minimum) M10 bolt and lock nut, or as recommended by the clamp
manufacturer, through the clamp hole in the mounting bracket.
If permanently installing the fixture, verify that the hardware (not included) and mounting
surface can bear at least 10 times the fixture's weight.
Working from a stable platform, clamp or fasten the fixture to the structure.
Install a safety cable that can hold at least 10 times the weight of the fixture through the
safety cable attachment point on the fixture.
Loosen the swivel locks, tilt the fixture to the desired angle, and retighten.
Verify that the fixture is at least 1 meter from any flammable surfaces.
Verify that the clearance around the air vents is at least 0.1 meters.
11