Mitsubishi HS-U577 Owner's Manual page 9

Hooking Up Your VCR
Connections to Satellite Receiver
If you have an RCA DSS
®
DSS , Panasonic DSS
PRIMESTAR ® , or DISH Network
system, you can connect the satellite receiver to
your VCR and then set up the VCR to change
the channels of the satellite receiver. This will
allow you to program your VCR to make
unattended recordings from several different
satellite channels.
1 Connect the red and white audio cable to
AUDIO OUT R and AUDIO OUT L on the
satellite receiver. Connect the other end to
the AUDIO IN R and AUDIO IN L on the
back of the VCR. Match the colors of the
connectors to the cables.
2 Connect the yellow video cable to VIDEO
OUTPUT on the satellite receiver. Connect
the other end to VIDEO IN on the back of
the VCR.
3 See page 9 for IR Emitter connection.
VCR Rear Panel
® , Sony DSS ® , Toshiba
® ®
, Hughes DSS ,
™ satellite
PRIMESTAR
DISH Network
Red
White
Yellow
connecting both a satellite receiver and a
cable box with audio video outputs
1 Connect the satellite receiver to the audio
video inputs on the back of the VCR as
shown.
2 Connect the cable box to the audio video
inputs on the front of the VCR.
You cannot connect both a satellite
receiver and a digital cable box.
You may need to purchase an audio
video cable for this hookup.
You will have to turn on your VCR to
watch the video or hear the audio from
the satellite receiver.
Refer to your Satellite Receiver
Owner's Guide for Satellite dish to
Satellite receiver connections, as well
as other possible video connections to
your TV.
®
DSS is a registered trademark of DirecTV, Inc.
®
is a registered servicemark of PRIMESTAR Partners LP.
™
is a registered trademark of EchoStar Communications Corp.
AUDIO
OUT
R
L
VIDEO
OUT
Satellite Receiver Rear Panel
S-VIDEO
Yellow
IMPORTANT
VIDEO L AUDIO R
OUT
OUT
White Red
R
L R
7