Mitsubishi HS-U577 Owner's Manual page 25

Table of Contents

Advertisement

Recording
Using One-Touch Recording (OTR)
One-Touch Recording (OTR) is a way to begin recording immedi-
ately, and have your VCR stop recording and turn off automatically
after your show is over.
1
Load a tape with its erasure prevention tab intact into the VCR.
2
Set the speed at which you would like to record by pressing
SP/EP on the remote control or REC SPEED on the front
panel.
3
Set the VCR's input to tuner by pressing INPUT on the remote
until a channel number shows on-screen. To record channels
from a PRIMESTAR
number with "SAT" appears on the screen.
4
Press CHANNEL on the remote control or on the front panel or
the number buttons on the remote to select the channel to be
recorded. If you are using a cable box that the VCR does not
control, select channel 3 or 4 on the VCR, and change the
channel on the cable box.
5
Press REC/˙REC LENGTH on the front panel twice. The first
time you press the button, recording will begin. The second
press of the same button adds 30 minutes to the OTR timer,
displayed on the front panel.
6
Press REC/˙REC LENGTH for each additional 30 minutes
you want to add to the OTR timer, up to 4 hours. If you press
the button 10 times, you will see End on the front panel display.
The VCR will record until the end of the tape. If you press the
button an eleventh time, the VCR will resume normal manual
recording.
The OTR timer will begin to count down backwards. When it
reaches zero, the VCR will stop recording and turn off.
If you program too much time into the OTR timer
Continue pressing REC/˙REC LENGTH. After the End point you
can start over from zero, adding time in 30 minute intervals.
How OTR affects other controls
If you press PAUSE during OTR, the VCR will pause recording, but
the OTR timer continues to count down.
Press PAUSE again to resume recording from the record-pause
mode. The REC/˙REC LENGTH will not resume your recording.
If you press STOP during OTR, you erase the OTR programming.
®
receiver, press INPUT until a channel
CHANNEL
1
2
3
4
5
6
7
8
9
0
X 2
REC SPEED
SP/EP
INPUT
REC
23

Advertisement

Table of Contents
loading

Table of Contents