Mitsubishi HS-U577 Owner's Manual page 20

Setting Up Your VCR
Selecting a Channel
Now that you have memorized channels, and added or deleted some, you will want to be able to select
channels. If you have not yet memorized channels, see page 14, Memorizing Channels Automatically.
(If you selected digital cable box, you cannot select any satellite channels.)
Antenna/Cable selections
indoor/outdoor antenna
cable antenna without box cable channels 1–125
cable box only
digital cable box
Satellite Receiver selections Your VCR can receive
Sony, RCA, GE, Toshiba,
Panasonic, Hughes,
™
DISH Network
Satellite Receiver selections Your VCR can receive
PRIMESTAR ®
If you try to select a channel number that the VCR cannot receive, the VCR will not change channels.
selecting antenna, cable or digital cable channels sequentially
Press CHANNEL on the remote control or on the VCR front panel. This will cycle through the channels in
sequential numerical order.
When you select the digital cable channels from 100 to 999, holding down the CHANNEL on the remote will
advance the channels in 10 channel increments.
selecting antenna, cable or digital cable channels directly
Use the number buttons on the remote control. For example, to choose channel 23, press 2-3. If you
select digital cable channels, you can select the three digits channels directly by using the number buttons.
For example, to choose digital cable channel 157, press the 1-5-7.
To select a single digit channel, such as channel 5; press 0-5. You can also press 5, then press ENTER.
selecting satellite channels sequentially
Press CHANNEL on the remote or on the VCR front panel. When pressing the up arrow, the lowest
satellite channel will follow the highest antenna or cable channel. When pressing the down arrow, the
highest satellite channel will follow the lowest antenna or cable channel. The other satellite channels will
follow in numerical order.
Continuously holding down CHANNEL on the remote will advance the channels in 10 channel increments.
selecting satellite channels directly
For Sony, RCA, GE, Toshiba, Panasonic, Hughes and DISH Network; press the number buttons on the
remote. For example, to go to channel 263, press 2-6-3.
For PRIMESTAR channels, press INPUT until the channel number with "SAT" appears on the screen.
Then press the number buttons on the remote.
For one or two digit channel numbers, press the number buttons, then press ENTER. For example, to go
to channel 29, press 2-9-ENTER.
18
Your VCR can receive
VHF/UHF channels 2–69
cable box channels 0–99
digital cable box channels 0–999
any channel from 100-999 provided
by your satellite service
(cable channels 100-125 cannot be selected)
any channel from 1-999 provided
by your satellite service
(cable channels 100-125 cannot be selected)