Mitsubishi HS-U577 Owner's Manual page 8

Hooking Up Your VCR
Connections to TV with Audio Video Inputs
Because you purchased a Hi-Fi VCR, you will
want to take advantage of its superior sound
capability and connect it to a stereo TV system
with audio and video inputs. This connection
also helps maintain the best picture quality.
1 Connect the red and white audio cable to
AUDIO OUT R (right) and AUDIO OUT L
(left) on the VCR. Connect the other end to
the TV's AUDIO IN RIGHT and AUDIO IN
LEFT. Match the colors of the connectors to
the cables.
2 Connect the yellow video cable to VIDEO
OUT on VCR. Connect the other end to
VIDEO IN on the TV.
3 Set the RF Converter to OFF. See page 47
for instructions on this setting, which can be
done at a later time.
VCR Rear Panel
6
AUDIO
OUT
R
Red
L
White
VIDEO
OUT
Yellow
TV Rear Panel
IMPORTANT
You may need to purchase an audio
video cable for this hookup.
Your TV Owner's Guide may have
additional suggestions for audio video
hookups.
To connect your VCR to a mono (non-
stereo) TV, connect only the white
AUDIO OUT L of the VCR and the white
AUDIO INPUT of the TV. Since the TV
is not stereo, you cannot take advantage
of your VCR's Hi-Fi stereo sound.
If you have an older TV without audio
video inputs, simply connect only the
antenna or cable as shown on the
previous page.
Yellow
White
INPUT-1
INPUT-2
OUTPUT
MONITOR/TUNER
S-VIDEO VIDEO
R
Red
L (MONO) R
AUDIO