Figure 24 - Rmc30 Browser Interface - Serial Port For Dnp3 - Siemens Ruggedcom RMC30 Technical Guidance Notes
Ethernet interface
Hide thumbs
Also See for Ruggedcom RMC30:
- Installation manual (36 pages) ,
- Installation manual (40 pages)
Table of Contents
Advertisement
Technical Guidance Notes
Figure 24 – RMC30 Browser Interface – Serial Port for DNP3
Click the link "Back" to return to the Main Menu and then click Configure Device Address Table to add
devices.
You need to add two devices, one for the PC (or Master) and one for the IED device.
In the example shown below I have given the PC address 3 and used its IP address (169.254.199.21)
when adding to the table.
©2007 Siemens Protection Devices Limited
Page 23 of 29
Advertisement
Table of Contents
